How to flash AzBox Me with Enigma 2 over Web interface

Share on Facebook0Tweet about this on TwitterShare on Google+0Digg thisShare on Tumblr0Email this to someone

How to flash AzBox Me with Enigma 2 over Web interface

This tutorial, which consist from screenshots will explain You how to flash Your AzBox Me with Enigma 2 or Neutrino HD image.

As far as we noticed, new AzBox bootloader allow You to install three (3) different Neutrino HD or Enigma 2 Images, so at boot it ask You which image You want to boot. In my case I am running official Neutrino HD on Boot 0, Enigma 2 v1.0 on Boot 1 and Enigma 2 TEST release on Boot 2.

So each time when receiver boot i can press on RCU button 1 or 2, or if i dont press anything receiver will by default boot to Neutrino HD which is installed on Boot 0.

1. Turn ON receiver by switching ON on the back panel and by pressing power button on RCU or Front panel and press VOL+, untill it show You on VFD that You are in rescue mode, where You will see also IP address of Your receiver.

2. Enter IP address which is shown on VFD to Your Web browser, and press enter.

3. Now on Your screen You will have this:

Click the image to open in full size.
4. After You have selected on which position You want to install Your Enigma2 or Neutrino HD image, than You will have this screen, on which You have to click on Browse button and to navigate where Your Enigma 2 flash file is located, and after you choose it click on Upload!:



No comments

You must be logged in to post a comment.