Solution for Remote Control and Super 5300 Clone

Share on Facebook0Tweet about this on TwitterShare on Google+0Digg thisShare on Tumblr0Email this to someone

Solution for Remote Control and Super 5300 Clone

My friends I will give you the solution for the remote starsat 5300 super, sometimes Tele command does not work correctly exp: 4 is the button Ok / CH + becomes Sub / FAV becomes OFF Etc. …..

Will have one side of the tuner EEPROM 24C02 number must Lier (Connect) with Pin 6 Pin 7 using a wire before it is necessary that the demo is off (OFF) when the Pin6 be connected with Pin 7 turn the receiver for 3 seconds, after removing the wire that connects the pin 6 with 7.

Result will be ready and the remote works fine without problemes.Cette method allows us not to remove the eeprom and load.

Click the image to open in full size.

Another tip in the case of losing the signal it is sufficient to Connect With 6 Pin 1


1 Comment. Leave new

Jaswant Chopra
October 4, 2015 5:47 pm

iptv test

You must be logged in to post a comment.